This is a complete kit to build an AeroQuad flight control board. It allows you to easily connect the Sparkfun 9DOF sensor (which includes the ITG 3200 triple axis gyro, the ADXL 345 triple axis accelerometer and the HMC 5883L triple axis magnetometer) to an Arduino Mega to create a 6 degree of freedom inertial measurement unit (IMU). Additionally the BMP 085 barometer is supported for altitude hold. These are proven sensors for rock solid quadcopter flight!
Using a shield is a great alternative to wiring the sensors and other connections by hand. It reduces the introduction of accidental errors, reduces the amount of wires for a cleaner build and ultimately saves you time getting your quadcopter in the air!
This is a complete kit to build an AeroQuad flight control board.
What is included:
- Arduino Mega 2560
- AeroQuad v2.2 Shield
- Stackable Header Pins to connect the Shield to an Arduino
- DC Connector to power Arduino
- Sparkfun 9DOF Sensor Board
- BMP 085 Barometer